Headlamp Range Control Positioning Motor (V48)/(V49)

Headlamp Range Control Positioning Motor (V48)/(V49)

The left headlamp beam adjustment motor (V48) or right headlamp beam adjustment motor (V49) is installed next to the low beam headlamp bulb in the headlamp in a replaceable manner.

• If the motors are removed and installed again or replaced, check the headlamp adjustment and adjust it again if necessary.

• The following figures show the removal and installation of the left headlamp control motor. The removal and installation of the right headlamp control motor are identical.

Removal

- Remove headlamp. Refer to=> [ Headlamps ] Headlamps.

- Remove the cover - 2 - from the back of the headlamp.






- Unclip the 3 wires to the control motor from the wire securing mechanism - 3 -.






- Turn the headlamp beam adjustment motor - 4 - in the - direction of the arrow - to the stop.

- Tilt the ball head of the control motor - 2 - upward out of the mount in the headlamp - 1 - and remove the control motor - 4 - from the headlamp housing.

- Remove the harness connector - 1 - from the control motor - 2 -.






Installation

Installation is performed in the reverse order of removal. Note the following:

- Install the harness connector on the control motor and insert the headlamp beam adjustment motor into the headlamp in the installation position.

- Tilt the ball head of the headlamp beam adjustment motor - 2 - from above into the mount - 1 - while pulling the reflector backward.






- Insert the control motor - 3 - into its mount and lock it by turning in the - direction of the arrow - to the stop.

- Clip the 3 wires to the control motor into the wire securing mechanism.

During installation, ensure proper seating of the cap. It is destroyed by entry of water into headlamp.

- Check headlamp for functions.

- Check the headlamp adjustment and adjust if necessary.