Installed Position and Tightening Torque of the Clamping Sleeve

Installed Position and Tightening Torque of the Clamping Sleeve

• Gradual introduction of clamping sleeves with a continuous clamp.

Tightening Torque and Installed Dimension of the Clamping Sleeve





- A - Clamping sleeve with 2 individual clamps

Tightening specification: 25 Nm

Installed dimension - a -: 5 mm (only for the front clamping sleeve)

- B - Clamping sleeve with a continuous clamp.

Tightening specification: 35 Nm

Installed dimension - a -: 8.5 mm (only for the front clamping sleeve)

Installed Dimension - a - for Vehicles with a Mark on the Front Exhaust Pipe





1 Clamping sleeve
2 Front exhaust pipe
a Installed dimension
A Mark

Installed Position of the Front Clamping Sleeve





- Install the clamping sleeve so that the bolt end - arrow - does not project beyond the lower edge of the clamping sleeve.

• Threaded connection points toward the right.

Installed Position of the Rear Clamping Sleeve





- Install the clamping sleeve so that the bolt end - arrow - does not project beyond the lower edge of the clamping sleeve.

• Threaded connection points to the rear