Headlamp Range Control Positioning Motor, Hella

Headlamp Range Control Positioning Motor, Hella

Removal

• If the motors are removed and installed again or replaced, check the headlamp adjustment and adjust it again if necessary.

• Illustrations depict replacement of headlamp beam adjusting motor at left headlamp.

• Replacing the headlamp range control positioning motor on the right headlamp is identical.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp. Refer to => [ Halogen Headlamps ] Halogen Headlamps.

- Pull off cover cap - 1 -.






- Disconnect the connector - 1 - from the headlamp range control positioning motor.






- Turn the headlamp range control positioning motor - 1 - in - direction of arrow - all the way until it stops and then pull it out of the mount - 2 -.






- Tip the headlamp range control positioning motor - 1 - so that it is possible to swing the ball head - 3 - downward and out of the ball head mount - 2 -.






- Remove headlamp beam adjusting motor out of headlamp housing.

Installation

Install in reverse order of removal, noting the following:

- Insert the headlamp range control positioning motor into the headlamp.

- Connect the connector.

- Carefully swing the ball head - 3 - back into the ball head mount - 2 -.






- Turn the motor - 1 - to the left all the way to lock it into place.


When installing the cover cap, make sure the cap is properly seated. It is destroyed by entry of water into headlamp.

- Check headlamp for function.

- Adjust the headlamp.

- Check the headlamp setting and adjust if necessary.