Tire Pressure Monitoring System Display, Performing Basic Setting

Tire Pressure Monitoring System Display, Performing Basic Setting

Applies only to tire pressure monitoring system display with PR number 7K6

Note:
Perform the basic setting on the tire pressure monitoring system display only "after" the tire pressures have been adjusted to the correct values.
If no pressure loss and no tire damage is detected after a tire pressure warning, the erroneous warning can be eliminated by a basic setting.

The tire pressure monitoring system display compares the speed and the rolling circumference on each wheel using the ABS sensors. The tire pressure monitoring system display shows when there is a difference in the rolling circumference on a wheel. The rolling circumference changes when:

- the tire pressure is too low.
- Tires have structural damage.
- Vehicle is loaded on one side.
- wheels of one axle are loaded higher, for example, when towing trailer or driving uphill and downhill.
- Snow chains are installed.
- Spare wheel is installed.
- One wheel per axle was replaced.

The yellow tire pressure monitoring system display indicator lamp is inside the instrument cluster -arrow-.





"BLINKING LIGHT" indicates that no "BASIC SETTING" has been performed yet.
"STEADY LIGHT", in conjunction with a warning tone, indicates "WARNING", a loss of pressure has been recognized, check tire pressure, perform system basic setting.

Perform "INITIAL" Basic Setting

- Switch ignition on.









- At the same time press the ESP -1- button and the SET -2- button in the center console for longer than 2 seconds.

The SET button is either in the center console or inside the glove compartment.
Press the ASR button if the vehicle does not have ESP.
Beginning of basic setting is confirm by a notifying tone.
On next new ignition start, warning does not appear.

Perfrom B Setting
- Switch ignition on.





- Press the SET button (either in the in the center console or inside the glove compartment) for longer then 2 seconds.

Tire Pressure Monitoring Display Indicator Lamp in instrument cluster -arrow- lights up as long as button is pressed

Beginning of basic setting is confirm by a notifying tone.

On next new ignition start, warning does not appear.