Crankshaft, Cylinder Block - Fastener Tightening Specifications

Fastener Tightening Specifications






• 1 Always replace

• 2 Lubricate the threads and contact surface.

Accessory Bracket Bolt Tightening Sequence and Specification






- Install the bolts for the accessory bracket as follows:

• Bolts - 1 and 2 - M10 x 52.

• Bolts - 5 and 6 - M10 x 60.

• Bolts - 3 and 4 - M10 x 30.

- Tighten the bolts in 4 steps in sequence - 1 through 6 -:

- Install the bolts all the way by hand.

- Tighten the bolts to 40 Nm.

- Tighten the bolts - 3 and 4 - an additional 45° (1/8) turn.

- Tighten the bolts - 1, 2, 5 and 6 - an additional 90° (1/4) turn.

Engine Mount Bracket Bolt Tightening Sequence and Specification






- Tighten the new bolts - 1 through 3 - in sequence to 40 Nm + an additional 180° (1/2) turn.