Front Bumper Cover

Front Bumper Cover

Removing






- Remove radiator grille.

- Remove the bolts - 4 -.

- Remove screws - 2 - (pointing upward) on the left and right sides of the wheel housing.

- Remove the screws - 3 - from the wheel housing.

- Remove the screws - 5 - and - 6 - from underneath.

A second mechanic is required for the rest of the removal procedure.

- Pull the front bumper cover - 1 - out of the guides on the left and right sides of the fender - arrows a -.

- Remove the front - 1 - parallel - arrows b - from the vehicle. A second technician is needed for this.

- Disconnect harness connectors of installed electrical components.

- Disconnect the hose coupling on the washer fluid hose.

Installing






- Install the front bumper cover - 1 - parallel - arrows a - onto the lock carrier.

- Press the front bumper cover - 1 - onto the guides until it latches - arrows b -.

• When installing front bumper cover, make sure it is guided on parallel on fender.

- Check the parallel alignment and the gap dimensions.

- Install the screws - 2, 3, 4, 5, and 6 - and tighten them to the tightening specification.

- Install the radiator grille.