Ribbed Belt

Ribbed Belt

Special tools, testers and auxiliary items required

• Locking Pin (T10060 A)

Removing

- Remove the noise insulation.

- Remove the front section of the right wheel housing liner..

Removing the Air Conditioning (A/C) Compressor Ribbed Belt

- Mark the rotation direction on the ribbed belt.

- Rotate the belt tensioner - 1 - in the - direction of the arrow - using a 15 mm box end wrench - A - as illustrated, and then lock it into place using the locking pin (T10060 A).






- Remove the A/C compressor ribbed belt.

Removing Generator, Power Steering Pump and Coolant Pump Ribbed Belt

- Relieve the tension on the belt tensioner - 1 - for the A/C compressor ribbed belt (remove the locking pin (T10060 A) ).

- Mark the running direction of the generator, power steering pump and coolant pump ribbed belt.

- Insert the locking pin (T10060 A) into the belt tensioner - 2 -.






- Rotate the belt tensioner - 2 - in the - direction of the arrow - using a 15 mm box end wrench - A - and then lock it into place using the locking pin (T10060 A).

- Remove the generator, power steering pump and coolant pump ribbed belt.

Installing

Install in reverse order of removal. Note the following:

- Place the generator, power steering pump and coolant pump belt around the pulleys, then lastly around the idler pulley - 3 -.






- Rotate the A/C compressor pulley before tensioning the generator, power steering pump and coolant pump ribbed belt. Make sure the ribbed belt is seated correctly on the pulleys.

- Before installing the A/C compressor ribbed belt, secure the belt tensioner using the locking pin (T10060 A).

• When installing the ribbed belt, note the rotation direction of the belt and be sure that it is seated correctly on the pulley.

- Start the engine and check the belt running direction.