Installing

Transmission, Installing

- Make sure the alignment sleeves are pressed into the engine flange.

- See how the plate fits between the engine and transmission. The plate must contact the engine along entire perimeter when pressing lightly against engine using both hands. If it is above the engine, then it is not hooked into the cylinder block correctly.

Further installation is performed in the reverse sequence.

The engine and the transmission must be installed to the subframe free of tension.

- Replace all transmission mount bolts.

- First, install all the new bolts by hand.

When installing, secure the transmission mount bracket to the transmission first. Tightening specification: 40 Nm + 90° (1/4) additional turn.

Adjust the old fit between both bolts using a screwdriver when tightening the bracket bolts to the vehicle. Tighten the two larger bolts to 60 Nm + 90° (1/4) additional turn.

Tightening specifications, transmission to engine. Refer to => [ Engine to Transmission Tightening Specifications ] Engine to Transmission Tightening Specifications.

- Adjust the selector lever cable. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

- Check the transmission fluid level. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.

- Perform a basic setting. To do this:

- Connect the vehicle diagnostic tester and then select "perform basic setting" using the guided function.