RCD 310 Sound System, Electronic Antitheft System

RCD 310 Sound System, Electronic Antitheft System

Special tools, testers and auxiliary items required

• Vehicle Diagnostic Tester

• Diagnostic adapter cable (VAS 5051/5a) or (VAS 5051/6a) or (VAS 5052/3)

Radio unit is equipped with an electronic Comfort Antitheft system which operates in conjunction with the instrument cluster.

After disconnecting the radio power supply, the radio is ready for use again once the power supply is connected. The Antitheft code does not need to be entered again. The requirement is that the first activation of the electronic Antitheft system follows and that the radio is reconnected in the same vehicle.

The Antitheft code is transmitted via the Vehicle Diagnostic Tester. The radio card and the label on the radio that were used in the past are no longer used.

• To access the Antitheft code the Vehicle Diagnostic Tester must be connected "Online"(network connection) and the user must provide a valid program user id to retrieve a radio code.

Antitheft System Antitheft Code, Deactivating

Accessing the code for the electronic Antitheft system using the VAS tester

Select Guided Fault Finding in Vehicle Diagnostic Tester.

After Diagnostic Trouble Code (DTC) memory of all control modules has been checked:

- Press button "Jump".

- Select "Function/Component Selection".

- Select "Body".

- Select "Electrical Systems".

- Select "01 self-diagnosis-enabled systems".

- Select "Radio navigation system"

- Select "Functions"

- Select and start "radio code inquiry".

An authorization to the system will be requested: Then the operating data, the VIN and the Radio/Radio Navigation System unit serial number will be automatically read out.

• When installing new radio / radio-navigation unit, or a unit which has not be adapted to the vehicle, it can happen that tester will not be able to read the serial number of the radio / radio-navigation unit. In this case, enter the serial number manually. The serial number can be found on a sticker on the unit and is also stamped into the side of the unit.

Then the Antitheft code will be displayed in the tester.

The radio Antitheft code must not be entered manually.

Electronic Antitheft System, Deactivating

- Switch on radio.

"SAFE" appears in the display for approximately 10 seconds, after that "1000"appears.

- Enter the Antitheft code numbers by pressing the function button as many times as necessary until the correct number sequence appears.

"OK" appears in the display after the four-digit code number has been entered.

- Once the correct Antitheft code number has been entered, press the "OK" button to confirm it.

Unit is enabled and ready for operation.

• If the Antitheft code has been entered incorrectly, it can be corrected immediately in another attempt. If Antitheft code is entered incorrectly twice, then the radio unit is locked for an hour. Then leave the radio unit and the ignition switched on. After one hour, the procedure for deactivating the electronic Antitheft system can be repeated. Keep in mind: Always two attempts to input code, after that the radio unit is locked for one hour.