Telephone Bracket

Telephone Bracket

Telephone base plate installation location - arrow -






Removing

Perform the following steps before starting:

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove cell phone from base plate.

- Remove the telephone baseplate by pulling it out of the instrument panel with gentle force in - direction of arrow -.






- Remove both TORX(R) screws from the cellular telephone mount.

- Remove wiring harness.

- Disconnect electrical connector.

Installing

- Connect connector and guide wiring harness back into instrument panel.

• Make sure that wiring harness is connected correctly.

- Install the cellular telephone mount.

- Position the telephone baseplate on the mount - arrow - and push it down until it audibly engages.