Lumbar Support, Power Seat

Lumbar Support, Power Seat

Removal and installation of lumbar support is described for left backrest frame. The same removal and installation instructions for lumbar support apply for right backrest frame.


Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions ] Airbag, Belt Tensioner and Battery Cut-Out Units, General Safety Precautions.

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Attach the seat to the fixture for seat repair (VAS 6136).

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Right Seat Trim

- Remove left power seat trim. Refer to => [ Left Power Seat Trim ] Left Power Seat Trim

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Secure backrest on fixture for seat repair (VAS 6136).

- Remove cover and cushion from the front seat backrest. Refer to => [ Front Seat Backrest Cover and Cushion ] Front Seat Backrest Cover and Cushion

- Remove front side airbag. Refer to => [ Driver and Passenger Side Airbag ] Driver and Passenger Side Airbag

- Disconnect wiring harness from drive motors - 1 - and - 2 -.

- Drill out rivet - 3 - in lower area on rear side.

- Drill out two rivets - 4 - on left side.

- Drill out two rivets - 5 - on right side.

- Disengage lumbar support from mounts in backrest frame - arrows -.

- Remove components of lumbar support from backrest frame.






Installing

- Install in reverse order of removal.

To install rivets - 3 -, - 4 - and - 5 -, use pop rivet pliers (VAS 5072).