RCD-310 Entry

RCD-310 Entry

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)

• The part number for the radio is on a label on the radio housing.

• Always deactivate the electronic anti-theft protection when replacing the radio. Refer to => [ Electronic Anti-Theft
System, Deactivating ] RCD-310 Entry. Give the customer the new radio code.

• If the radio code is not known, it can be retrieved via the known systems. The radio serial number is needed. It is on a sticker on the side of the radio housing. The serial number is also stamped into the side of the radio itself.

Removing


• Turn off the ignition and all electrical consumers.

• Remove the key.

- If there is a CD still in the radio, remove it. Refer to the Operating Instructions.

Only Jetta from MY 2011

- Remove the cover - 2 - from the instrument panel - 1 - using a (3409).






All Except Jetta from MY 2011

- Remove the vents from center of the instrument panel.

- Remove the screws - arrows -.






- Remove the trim from center of the instrument panel.

All Vehicles

- Remove screws - arrows -.






- Pull the radio out of the installation slot until the connectors on the back are accessible.

- Squeeze the connector lock in direction of the - arrows -.






- Move the locking bracket in the direction of the - arrow - and remove the connector.






- Unlock the antenna connections - arrows - and disconnect the connectors.






Installing

Install in reverse order of removal. Note the following:

• Never push directly on the display or the buttons when inserting the radio.

- Install the screws - arrows - in the radio.






- Deactivate the electronic anti-theft protection. Refer to => [ Electronic Anti-Theft
System, Deactivating ] RCD-310 Entry.

- Check the radio coding. Code it again if necessary. Refer to => [ RCD-310 Entry Components, Adapting ] RCD-310 Entry Components, Adapting.

Torque specifications: 1.5 Nm