Converter with Socket

Converter with Socket

Special tools, testers and auxiliary items required

• Trim Removal Wedge (3409)


• The Converter with Socket, 12V, 230V (U13) / Converter with Socket, 12V-115V (U27) housing contains condensers that can be charged with residual voltage.

• There is a danger of electric shock.

• The Converter with Socket, 12V, 230V/Converter with Socket, 12V-115V housing must not be opened under any circumstances.


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

• The connections, wires or 115 volt socket must not be repaired under any circumstances.

• If there is a connection, wire or 115 volt socket malfunction, replace the entire unit.

Removal

- Open the cover - 1 -.

- Remove the cover from the socket - 2 - using (VAS 3409). It is clipped on both sides of the socket.

- Remove the two screws - 3 -.

- Remove the inner socket unit - 4 -. Both side brackets - 5 - must be loosened to do this.






- Disconnect the connector - 1 -.






- Release the socket - 4 - at the tabs - arrows - and remove the socket.






- Remove the bolts - 2 and 3 -.

- Remove the inverter - 1 -.

Installation

Install in reverse order.

Screw tightening specification: 1.5 Nm