Glass Panel

Glass Panel

Removing






- Open the glass panel - 1 - until the trim - 2 - is accessible.

- Engage the retaining tabs - 3 - by pressing on the back side in the direction of - arrow A -.

- Pull the trim - 2 - inward in the direction of - arrow B - and remove it from the bolt - 4 -.

- Slide the trim forward in the direction of - arrow C - and remove it.

- Remove the left and right screws - 2 - from the glass sunroof panel - 1 -.






• When removing the screws, use a magnetic tool so that the screws cannot fall into the sunroof mechanism.

- Remove the glass sunroof panel upward.


Do not try to use the tilt feature when the glass sunroof panel is not installed, otherwise the wind deflector could be damaged (scratched).

Installation

• Always use new screws when installing or removing the glass sunroof panel.

• When installing the screws, use a magnetic tool so that the screws cannot fall into the sunroof mechanism.

- Insert the glass sunroof panel - 1 - from the top and install the screws - 2 - but do not tighten them.






- Install the front glass sunroof panel. Refer to => [ Front and Rear Glass Panel Height, Adjusting ] Front and Rear Glass Panel Height, Adjusting

- Tighten the screws - 2 - to 5 Nm.

- Engage the front of the trim - 2 - in the glass panel - 1 - - arrow A -.






- Press the trim in the direction of the - arrow B - onto the bolt - 4 - and clip the retaining tabs - 3 - in on the rear side.

- After completing all the work, perform an sunroof motor adaptation, refer to => [ Adaptation Panorama Sunroof ] Adaptation Panorama Sunroof.