Front Seat Backrest Cover and Upholstery

Front Seat Backrest Cover and Upholstery

• The following describes removing and installing components on the left seat. Removing and installing components on the right seat is identical.

Removing

Perform the following:

- Install the (VAS 6136) on the (VAS 6095).

- Remove the front seat. Refer to => [ Front Seat ] Front Seat.

- Secure the seat on the (VAS 6136).

- Remove the left trim on the seat:

• Remove the left trim on the seat without height adjustment. Refer to => [ Left Seat Trim without Height Adjustment ] Left Seat Trim without Height Adjustment.

• Remove the left trim on the seat with manual height adjustment. Refer to => [ Left Seat Trim with Manual Height Adjustment ] Left Seat Trim with Manual Height Adjustment.

• Remove the left trim on the seat with power height adjustment. Refer to => [ Left Seat Trim with Power Height Adjustment ] Left Seat Trim with Power Height Adjustment.

- Remove the right trim on the seat. Refer to => [ Right Seat Trim ] Right Seat Trim.

All vehicles

- Remove the front seat backrest. Refer to => [ Front Seat Backrest ] Front Seat Backrest.

- Mount the backrest in the (VAS 6136).

- Pus the cushion on the headrest guide - arrow -.






- Push the headrest guide - arrow - all the way using (3409).

- Push the button - 2 - and pull the headrest - 1 - out of the backrest.

Vehicles with Manual Lumbar Support Adjustment

- Remove the lumbar adjustment lever - 2 - using the (3392).

All Vehicles

- Open the retaining channel - 5 - in direction of - arrow -.

Cover with Map Pocket

- Remove the clip - 3 - from both sides of the back of the backrest frame - 4 -.






- Fold up the backrest cover - 1 - slightly upward.

- Disengage tension wire - 5 - on the left and right sides of the backrest frame.

- Remove the upholstery clips - 1 - from the retainers - 2 - in the cushion - 4 - alternating from side to side using a small screwdriver.

- Fold the cover - 1 - up further and remove it from the cushion - 3 -.

- Push the cushion - 3 - over both headrest guides and remove it from the backrest frame.






Vehicles with Seat Heating

• If, on a vehicle with seat heating, the cushion - 1 - or the backrest heating element - 2 - is faulty, always replace both components.






Installation

- Push the cushion - 5 - over both headrest guides and onto the backrest frame.

- Attach the cover - 1 - to the cushion - 5 - with the clips - 4 -.

- Attach the cover - 1 - to the cushion - 5 - with new upholstery clips - 2 - at the shown locations - 3 - using the (V.A.G 1634).






Further assembling is in reverse order of removal.