Assembly Unit

Assembly Unit

Removing






- Lower the headliner but do not remove it from the vehicle.

- Remove the water drain hoses from the connections - arrows - on the assembly unit - 1 -.

- Disconnect the connector from the sunroof motor - 5 -.

A second technician is required for the rest of the removal procedure.

- Remove the bolts - 3 - and the assembly unit - 1 - from the vehicle. A second technician will be needed to do this.

Installing






Perform the following:

- With a second technician helping, insert the assembly unit - 1 - into the roof opening.

- Line up the assembly unit - 1 - over the two cylindrical pins at the front right 12 mm - 4 - and rear left 10 mm - 2 - inside the roof.

Installation unit must not make contact with roof frame.

- Install the bolts - 3 - but do not tighten them.

- Check the routing of the electrical consumer wires and connectors on the roof and correct if necessary.

- Tighten the 2 bolts - 3 -, right front and left rear.

- Tighten the left and right bolts - 3 - on the assembly unit - 1 -.

- Tighten the front bolts - 3 - on the assembly unit - 1 -.

Bolt - 3 - tightening specification: 8 Nm

- Attach the water drain hoses to the connections - arrows - on the assembly unit - 1 -.

- Install the headliner.