Cover Plate

Cover Plate

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

• Torque Wrench (V.A.G 1332)

• Piston Compressing Tool (T10145)

Removing


When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

Do not open the brake hydraulic system when removing!

- Loosen the wheel bolts.

- Raise the vehicle.

- Remove the wheel.

- Remove brake disc. Refer to => [ Brake Disc ] Brake Disc.

- Remove the wheel bearing unit.

- Unscrew the threaded connection - arrows - on the cover plate - 1 -.






- Remove the cover plate - 1 - and the stub axle.

Cleaning


Do not blow brake system using compressed air, the dust produced is harmful to health!

• Use only appropriate solvents for cleaning brake system.

Installing

Install in reverse order of removal. Note the following:

If using the brake pads again, install the marked pads in the same location.

- Secure the brake caliper with new self-locking screws.

• Each time after replacing brake pads, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.

• Check the brake fluid level after removing the brake pads.

- Install the wheel and tighten.

Tightening Specification