Accelerator Pedal Module, Removing and Installing

Accelerator Pedal Module, Removing and Installing

Special tools, testers and auxiliary items required

• Release tool (T10238)

Perform the following:

Removing

- Remove the steering column cover - arrows -.

- Pry off the cap - 3 - using a screwdriver.

- Remove bolts - 2 -.

- Disconnect the connector - 1 -. Refer to => [ Accelerator Pedal Module Connector, Disconnecting and Connecting ].

- Install the release tool (T10238) all the way into the opening as illustrated.

- Remove the accelerator pedal module.

Installing

- Connect the connector - 2 - to the accelerator pedal module - 5 -. Refer to => [ Accelerator Pedal Module Connector, Disconnecting and Connecting ].

- Push the accelerator pedal module onto the bolt - 5 -.

- Insert the centering pin - 6 - into the hole in the floor panel.

- Secure the accelerator pedal module with the bolt - 2 -.

- Install the cap - 3 -.

- Install the steering column cover - arrows -.

- If the accelerator pedal module was replaced, adapt it to the engine control module => Vehicle Tester "Guided Functions".

- If accelerator pedal module was replaced in a vehicle with an automatic transmission, then the kick-down function must be programmed. => Vehicle Diagnosis Tester "Guided Functions".

Tightening specification:

Accelerator Pedal Module Connector, Disconnecting and Connecting

Disconnecting connector 8K0 973 706

- Pull the slider - A - (red) all the upward in - direction of arrow 1 -.

- Push the slide in - direction of arrow 2 - and remove the connector housing - B - upward in - direction of arrow 3 -.

The slider - A - stays in the upper position.

Connecting connector 8K0 973 706

- Push the connector housing - B - all the way down in - direction of arrow 1 -.

- Push the slider in - direction of arrow 2 - and downward in - direction of arrow 3 -.

The slider - A - can be pushed down only if the connector housing was pushed all the way down.

- Pull on the connector to make sure it is secure.