Fuel Gauge Sender: Service and Repair

Fuel level sensor (G), Removing and Installing

Perform the following:

Removing

- Remove the fuel delivery unit => [ Fuel Delivery Unit, Removing and Installing ] Service and Repair.

- Move the fuel level sensor (G) slightly to the side and upward at the same time.






- If the sensor cannot be released this way, also press the retaining tab - arrows - to the side slightly.






- Write down the colors of the cables for installing later.






- Unlatch and disconnect the connectors - 1 - and - 2 - and - 3 -. Bend the hooks back.

Installing

- Disconnect the connectors - 1 - and - 2 - and - 3 -. Note the colors.






- Pull on the connector to make sure it is secure.

- Insert the fuel level sensor (G) in the guide on the fuel delivery unit and push down until it engages.

- Install the fuel delivery unit => [ Fuel Delivery Unit, Removing and Installing ] Service and Repair.