Diagram 17/2 (Tracks 1-14)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


Steering angle sensor, Steering torque sensor, Power steering control module, Data bus on board diagnostic interface, Fuse 3 (on fuse panel A), Fuse 14 (on fuse panel C), Electromechanical power steering motor





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

A - Battery

G85 - Steering angle sensor Locations [1][2]Diagrams

G269 - Steering torque sensor Locations [1][2]Diagrams

J500 - Power steering control module Locations Overview Of Control Modules [1][2]Diagrams

J533 - Data bus on board diagnostic interface, under the instrument panel, left Overview Of Control Modules

SA3 - Fuse 3 (on fuse panel A) Overview of Fuses (SA), (SB), (SC)

SC14 - Fuse 14 (on fuse panel C) Overview of Fuses (SA), (SB), (SC)

T2a - Double connector

T3 - 3-pin connector

T5al - 5-pin connector

T5g - 5-pin connector

T6z - 6-pin connector, near the left headlamp Overview Of Connector Stations and Connectors

T20 - 20-pin connector

T73b - 73-pin connector Overview Of Control Modules

V187 - Electromechanical power steering motor Locations [1][2]Diagrams

(508) - Terminal 30 threaded connection (on E-box)

(640) - Ground connection 2 in engine compartment, left

(A199) - Positive connection 4 (15a) (in instrument panel wiring harness)

(B383) - Powertrain CAN bus high connection 1 (in main wiring harness)

(B390) - Powertrain CAN bus low connection 1 (in main wiring harness)

* - Refer to applicable standard equipment wiring diagram

*2 - only for vehicles with High equipment (AW1)

*3 - only for vehicles with Low equipment (AW0)