Sunroof with Glass Panel, Glass Panel Height Adjustment

Glass Panel Height Adjustment

The boot is still not removed:

- Move the sun shade all the way back.

- Tilt open the sunroof.

- Unclip the boot on the lower strip.






- Loosen both front retainers and push the boot to the rear - arrow - and out of the guide.

- Move the glass panel to the neutral position.

All vehicles:

- Loosen the bolts - 1 through 3 - but do not remove them.






- To prevent wind noise, adjust the front and rear height of the glass panel as shown in the illustrations.

Adjusting the height at the front glass panel (the - arrow - points in direction of travel).






- a - = 0 to 1 mm lower than roof

- Tighten the front bolts for the glass panel.

Tightening specification: 7 Nm

Adjusting the height of the back of the glass panel (the - arrow - points in direction of travel).






- b - = 0 to 1 mm higher than roof

- Tighten the rear bolts for the glass panel.

- Tighten the center bolts for the glass panel.

Tightening specification: 7 Nm

- Tilt open the sunroof.

- Install the boot into the mounts onto the slotted guide rail guide.






- Clip the boot into the frame.