Power Window Switch in Rear Door (E52)/(E54)

Power Window Switch in Rear Door (E52)/(E54)

Trim Removal Wedge (VAS 3409)


• Turn off the ignition and all electrical consumers.

• Remove the key.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( Trim Removal Wedge (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

The Left Rear Power Window Switch In Left Rear Door (E52) and Right Rear Window Switch In Right Rear Door (E54) are removed and installed the same way so the procedure is only described for one of them.

Removing

- Remove the handle trim at the tabs - arrows - - 1 - using trim removal wedge (VAS 3409) from the pull handle - 2 -.






- Disconnect the connector - 2 -.






- Open the four tabs - arrows - and remove the Right Rear Window Switch In Right Rear Door (E54) - 2 - from the handle trim - 1 -.






Installing

Install in reverse order of removal. Note the following:

- Make sure the tabs click into place when installing.