Diagram 138/3 (Tracks 15-28)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


Windshield wiper intermittent mode switch, Windshield and headlamp washer pump switch, Engine coolant level sensor, Windshield washer fluid level sensor, Instrument cluster control module, Vehicle electrical system control module, Steering column electronics control module, Data bus on board diagnostic interface, Windshield washer fluid level indicator lamp





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

E22 - Windshield wiper intermittent mode switch

E44 - Windshield and headlamp washer pump switch

G32 - Engine coolant level sensor Locations

G33 - Windshield washer fluid level sensor

J285 - Instrument cluster control module Locations

J519 - Vehicle electrical system control module Locations

J527 - Steering column electronics control module Locations Locations Steering Column Electronics Control Module -J527-

J533 - Data bus on board diagnostic interface Locations

K37 - Windshield washer fluid level indicator lamp

T16p - 16-pin connector

T20 - 20-pin connector

T32c - 32-pin connector

T52c - 52-pin connector

(367) - Ground connection 2 (in main wiring harness)

(410) - Sensor ground connection 1 (in main wiring harness)

(602) - Ground connection in left front footwell

(A201) - Positive connection 6 (15a) (in instrument panel wiring harness)

(B397) - Comfort system CAN bus high connection 1 (in main wiring harness)

(B406) - Comfort system CAN bus low connection 1 (in main wiring harness)

Previous Diagram 138/2 (Tracks 1-14)