Crankshaft Seal, Transmission Side

Crankshaft Seal, Transmission Side

Special tools, testers and auxiliary items required

• Assembly Tool (T10122)

• Pulling Hook (T20143)

Removing

- Remove the transmission.

- Lock the crankshaft. Refer to => [ Crankshaft, Locking ] Procedures.

- Remove the flywheel or the drive plate and remove the sensor wheel for the engine speed sensor (G28) from the crankshaft.

- Pull out the seal using the pulling hook (T20143/2).






Do not damage the crankshaft sealing surface when doing this.

Installing

• Do not additionally lubricate or grease the sealing lip of the seal!

- Clean the sealing surfaces. They must be free of oil and grease.

- Before installing, remove any remaining oil from the end of the crankshaft with a clean cloth.

- Insert the assembly device (T10122/1) onto the pull sleeve (T10122/2) and slide the seal - A - onto the pull sleeve.






- Remove the assembly device (T10122/1).

- Install the pull sleeve (T10122/2) with the seal - A - onto the crankshaft.






- Press in the seal all around evenly and flush using the pressure sleeve (T10122/3).

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the locking pin (T40069) from the rear of the cylinder block and install the locking bolt.

Tightening Specifications