Removal and Replacement

Exhaust System, Installing

• The engine must be cold.

- Loosen the front clamping sleeve nuts - 3 and 4 -.






- Align the front clamping sleeve - 1 - to the mark - A - on the front exhaust pipe - 2 - (- arrow - faces in the direction of travel).

• - a - = 5 mm

• The connections must be at the right and must not project beyond the lower edge of the clamping sleeve.

- Push the rear muffler as far forward into the clamping sleeve until 6.6 mm - a - is reached between the suspended mount/body and the suspended mount/rear muffler. - Arrow - indicates the direction of travel.






- Align the rear muffler horizontally.

- Tighten the threaded connections of the clamping sleeve in this position, refer to => [ Clamping Sleeve Installed Position ] Procedures.