Diagram 34/2 (Tracks 1-14)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


High pressure sensor, Fresh air blower control module, A/C control module, A/C compressor regulator valve





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

G65 - High pressure sensor Locations Diagrams

J126 - Fresh air blower control module Locations Fresh Air Blower Control Module -J126-

J301 - A/C control module Locations A/C Control Module -J301-

J519 - Vehicle electrical system control module Locations

J533 - Data bus on board diagnostic interface Locations

N280 - A/C compressor regulator valve Locations [1][2]Diagrams

SC4 - Fuse 4 (on fuse panel C) Overview of fuse holder

SC25 - Fuse 25 (on fuse panel C) Overview of fuse holder

SC27 - Fuse 27 (on fuse panel C) Overview of fuse holder

T2gt - Double connector

T3c - 3-pin connector

T4t - 4-pin connector

T6u - 6-pin connector

T10a - 10-pin connector

T16g - 16-pin connector

T20 - 20-pin connector Locations

T20c - 20-pin connector

T52c - 52-pin connector

V2 - Fresh air blower Locations [1][2]Blower Motor

(43) - Ground connection on A-pillar, lower right Locations

(132) - Ground connection 3 (in engine compartment wiring harness)

(366) - Ground connection 1 (in main wiring harness)

(376) - Ground connection 11 (in main wiring harness)

(388) - Ground connection 23 (in main wiring harness)

(639) - Ground connection on left A-pillar Locations

(655) - Ground connection on left headlamp Locations

(A189) - Positive connection 5 (30a) (in instrument panel wiring harness)

(A217) - Positive connection 8 (15a) (in instrument panel wiring harness)

(B397) - Comfort system CAN bus high connection 1 (in main wiring harness)

(B406) - Comfort system CAN bus low connection 1 (in main wiring harness)

Next Diagram 34/3 (Tracks 15-28)