Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor G40

Component location, see - item 3 - in the => [ Cylinder Head Overview ] Cylinder Head Overview.

- Remove the noise insulation.

- Remove the toothed belt. Refer to => [ Toothed Belt ] Toothed Belt.

- Release and disconnect the connector - 1 - from the camshaft position sensor.






- Unclip the connector on the coolant pipe.

- Remove the camshaft position sensor - arrow -.






- Remove the ribs with a screwdriver and remove the cover for the repair opening - arrows -.






- Remove the camshaft position sensor from the cylinder head and guide the connector through the opening in the toothed belt guard.

Installing

Install in reverse order of removal. When doing this note the following:

• Seal off the opening in the toothed belt guard with a rubber plug. Refer to the Parts Catalog.

- Install the toothed belt. Refer to => [ Toothed Belt ] Toothed Belt.

Tightening Specifications