Front and Rear Door Side Molding Installation Instructions

Front and Rear Door Side Molding Installation Instructions

• Warm the body side molding with hot air blower (V.A.G 1416).

• Use only adhesive remover (D 002 000 10) to remove any remaining adhesive if removing the body side molding.

• Remove any adhesive residue left by the tape using adhesive remover (VAS 6349).

• Make sure the adhesive surfaces are free of dust and grease.

• Install the body side molding immediately after cleaning.

• Only remove the protective film right before assembly.

• The temperature must be approximately 70°F (21 °C).

• It is not possible to remove the body side moldings without damaging them.