Sunroof Glass Panel

Sunroof Glass Panel

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1783)

Removing

- Move the sun shade all the way back.

- Tilt open the sunroof.

- Unclip the boot on the lower strip.






- Loosen both front retainers and push the boot to the rear - arrow - and out of the guide.

- Move the glass panel to the neutral position.

- Remove the bolts - 1 - and - 3 -.






- Loosen the bolt - 2 - a few turns but do not remove it.

- Remove the glass panel from the roof opening.

Installation

• The guide pin - 1 - must line up with the marking - arrow - on the left and right slotted guide rail.






If this is not the case, adjust parallel movement. Refer to => [ Glass Panel, Adjusting Parallel Movement ] Glass Panel, Adjusting Parallel Movement.

- Install the glass panel from the top into the roof opening.

- Install the bolts - 1 - and - 3 - and tighten them only after adjusting the height of the glass panel.






- Adjust the height of the glass panel. Refer to => [ Glass Panel Height Adjustment ] Glass Panel Height Adjustment.