Plenum Chamber Cover

Plenum Chamber Cover

Removing

• Removing and installing the plenum chamber cover may slightly differ depending on the model.






- Remove the wiper arms.

- Remove the seal - 2 - from the entire length of the plenum chamber covers - 1 -.

The windshield - 5 - could break. Do not pry off plenum chamber cover - 1 - using a leverage tool (screwdriver, wedge). This could damage the windshield - 5 -, which could later crack.

- Starting at the edge of the windshield - 5 - and working up, pull the plenum chamber covers - 1 - out of the retainer - 6 -.

- Remove the plenum chamber cover - 1 - from the vehicle.

The molded foam part - 3 - and - 4 - remains attached.

Installation

The windshield - 5 - could break.

Using a hammer to install the plenum chamber - 1 - into the binding profile - 6 - on the windshield - 5 - can cause the windshield to crack.






• New windshields have an insert in the retainer. Remove the insert before installing the plenum chamber cover.

• Press the plenum chamber cover into the retainer lightly by hand. Do not strike it or press on it with a tool.

- Spray the retainer - 6 - with soapy water to make it easier to install the plenum chamber covers - 1 -.

- Position the left plenum chamber cover - 1 - on the retainer - 6 - and then, starting in the middle, press it into the retainer - 6 -.

- Push the seal - 2 - all the way into the installed molded foam parts - 3 - and - 4 -.

- Install the seal - 2 - on the plenum chamber covers - 1 -.

- Install the wiper arms.