Inner Door Seal

Inner Door Seal

The inner door seals are equipped at the factory with sealant, applied to the door flange and then rolled on.

• The sealant on the inside will spread when the seal is removed. The sides will bend up slightly. If the seal is being installed again, the sealing performance and proper seating are no longer guaranteed.

• For this reason, every seal, that has been removed completely, must be replaced with a "hammer-stroke seal".

• For partially removed seals, seal flanks must be pressed together before installation.

• Removing and installing is described only for the left inner door seal. Removing and installing the right inner door seal is identical.

Removing






Perform the following:

- It is necessary to remove the necessary pillar trim in order to remove the inner door seal.

- Remove the sill panel strip.

- Remove the inner door seal - 1 - from the flange on the body.

Installation






Perform the following:

- Line up the inner door seal - 1 - with the vulcanized point - arrow b - with the lower hinge - arrow a -.

- Install the inner door seal - 1 - starting at the top of the door opening - arrow a -.

- Install the sill panel strip.

- Install the pillar trim.