Procedures

Instrument Panel, Aligning in Vehicle

• Instrument panel can be aligned in height and diagonally to direction of travel.

Perform the following:

- Remove the wiper arms.

- Remove the plenum chamber cover.

- Remove the instrument panel side covers - 1 - and - 2 -. Refer to => [ Instrument Panel Side Cover ] Instrument Panel Side Cover.

- Remove the center console trim - 3 - and - 4 -. Refer to => [ Center Console ] Center Console.






- Just loosen the bolts - 1 - and - 2 - (2-3 turns) (20 Nm).






- Loosen the bolt - 1 - and - 2 - (2-3 turns) (20 Nm).






- Loosen the bolts - 1 - and - 2 - (2-3 turns) (20 Nm).






Aligning Height

• Instrument panel height is set using eccentric screws - 1 - and - 2 -.

• In the zero position, the longer eccentric surface faces toward outside of vehicle.

• Eccentric must not be turned more than ±90° out of zero position.

- Adjust the height of the instrument panel using the adjusting screws - 1 - and - 2 - on both sides.

• Raise the instrument panel on the left side in - direction of arrow A -.

• Raise the instrument panel on the right side in - direction of arrow B -.

• Lower the instrument panel on the left side in - direction of arrow D -.

• Lower the instrument panel on the left side in - direction of arrow C -.

Aligning Width

- Adjust the instrument panel vertically.

• The instrument panel may only touch the flat surfaces marked in the - screen - when adjusting the instrument panel laterally.






- After aligning the instrument panel inside the vehicle, tighten it to the tightening specification.

Installation of removed components is reverse of removal.