Camshaft Adjustment Valve, Checking

Camshaft Adjustment Valve, Checking

Special tools, testers and auxiliary items required

• Multimeter.

• Wiring diagram.

Test requirements

• The Camshaft Adjustment Valve 1 (N205) fuse OK.

• Engine Control Module (ECM) Power Supply Relay (J271) OK, checking.

• Battery voltage at least 12.5 volts.

• All electrical consumers such as, lights and rear window defroster, switched off.

• Vehicles with automatic transmission, shift selector lever into position "P" or "N".

• A/C switched off.

• Ground connections between engine/transmission/chassis OK.

• Ignition switched OFF.

Test procedure

- Perform a preliminary check to verify the customers complaint. Refer to => [ Preliminary Check ] Preliminary Check

Start diagnosis

- Remove the engine cover with air filter. Refer to the Repair Information.

- Disconnect Camshaft Adjustment Valve 1 (N205) electrical harness connector.

- Using a multimeter, check the Camshaft Adjustment Valve 1 (N205) for resistance.

Specified value: 5.0 to 9.0 ohms (at approx. 20 °C)

If the specified value was Not obtained:

- Replace the Camshaft Adjustment Valve 1 (N205) Refer to the Repair Information.

If the specified value was obtained:

Checking voltage

- Start the engine.

- Using a multimeter, Check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 1 for voltage.

- Switch the ignition OFF.

Specified value: Battery voltage.

If the specified value was Not obtained:

- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground. Replace any open fuse. Refer to the wiring diagram for circuit detail.

- Check the wiring connection for damage, corrosion, loose or broken terminals.

- If necessary, repair the faulty wiring connection.

If the specified value was obtained:

- Turn the ignition On.

- Using a multimeter, Check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 2 to ground for voltage.

- Switch the ignition OFF.

Specified value: near 3.53 V.

If the specified value was obtained:

- Replace the Camshaft Adjustment Valve 1 (N205) Refer to the Repair Information.

If the specified value was Not obtained:

Checking wiring

- Remove the Engine Control Module (ECM) (J623). Refer to the Repair Information.

- Using a multimeter, Check the Camshaft Adjustment Valve 1 (N205) electrical harness connector terminal 2 to the Engine Control Module (ECM) electrical harness connector T60 for an open circuit. Refer to Wiring Diagrams for pin locations.






Specified value: 1.5 ohms Max.

If the specified value was Not obtained:

- Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground.

- Check the wiring connection for damage, corrosion, loose or broken terminals.

- If necessary, repair the faulty wiring connection.

If no malfunction is found in the wiring and terminal 2 voltage supply was Not OK:

- Replace the Engine Control Module (ECM) (J623). Refer to the Repair Information.

- Install the engine cover with air filter. Refer to the Repair Information.

Final procedures

After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] Diagnostic Modes 01 - 09.

2. If necessary, erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] Diagnostic Modes 01 - 09.

3. If the DTC memory was erased, generate readiness code. Refer to => [ Readiness Code ] Monitors, Trips, Drive Cycles and Readiness Codes.