Ignition Switch (D)

Ignition Switch (D)

Always follow the instructions in the Repair Information exactly when disconnecting and connecting the battery. Refer to battery in engine compartment => [ Battery, Disconnecting and Connecting ] Service and Repair or battery in luggage compartment => [ Battery, Disconnecting and Connecting ] Service and Repair.

• Risk of airbag deployment!

• The airbag unit could deploy if mishandled.

• Read all the Safety Precautions before working on the airbag.

Removing

- Disconnect the battery. Refer to battery in engine compartment => [ Battery, Disconnecting and Connecting ] Service and Repair or battery in luggage compartment => [ Battery, Disconnecting and Connecting ] Service and Repair.

- Remove the steering wheel.

- Remove the steering column trim.

- Disconnect the connector - 2 - from the ignition switch - 1 -.






- Unlock the ignition switch with a small screwdriver - arrows -.

- Remove the ignition switch - 1 - from the steering lock housing.

Installing

- Install the ignition switch in the steering lock housing until it audibly latches.

- Insert ignition key into lock cylinder and turn into position "Drive".

Lock cylinder key positions





1. Position Off

2. Position Run

3. Position Start


Further installation is done in reverse order of removal.