Selector Shaft Seal

Selector Shaft Seal

Special tools, testers and auxiliary items required

• Thrust Piece (T10174)

Removing

- Remove the multifunction transmission range switch. Refer to => [ Multifunction Transmission Range Switch F125 ] Service and Repair.

- Carefully pry out the selector shaft seal using a screwdriver. Be careful not to damage the selector shaft when doing this.

Installing

- Coat the outer circumference and the sealing lip on the seal with Automatic Transmission Fluid (ATF).

• Installed position: The open side of the seal faces the transmission housing.

- Install the new seal until seated using the thrust piece (T10174). Do not tilt the seal.






- Install the multifunction transmission range switch. Refer to => [ Installing ] Service and Repair.