Right Luggage Compartment Side Trim Panel, without Access Cover SCR (Selective Catalytic Reduction) inside Luggage Compartment

Right Luggage Compartment Side Trim Panel- Vehicles without an Access Cover SCR (Selective Catalytic Reduction) inside Luggage Compartment

Removing

- Turn off the ignition.

- Remove the luggage compartment carpet.

- Remove the luggage compartment carpet support.

- Remove the backrest.

- Remove the rear wheel housing trim. Refer to => [ Lower C-Pillar Trim ] Lower C-Pillar Trim.

- Remove the rear lock carrier cover. Refer to => [ Lock Carrier Trim ] Lock Carrier Trim.

- Loosen the rear shelf near the luggage compartment right side trim panel as far as necessary. Refer to => [ Rear Shelf ] Rear Shelf.

- Loosen the right luggage compartment lamp (W35) - 1 - in - direction of arrow - and remove it from the luggage compartment trim panel. Disconnect the connector - 2 - at the same time.






- Remove the clips - 1 -.

- Remove the trim panel - 2 - in - direction of arrow -. Loosen the trim panel from the rear lid seal molding.

- Depending on the vehicle equipment level, disconnect any wiring harnesses and remove the trim panel - 2 - from the vehicle.






Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary.

• Make sure the side luggage compartment trim panel fits inside the rear lid seal molding after it is installed.