A-Pillar Gap Cover

A-Pillar Gap Cover

• Removing and installing on the left side of the vehicle is described here. Removing and installing on the right side is identical.

Removing

- Remove the instrument panel cover on each side. Refer to => [ Instrument Panel ] Instrument Panel.

- Loosen the A-pillar center trim - 2 - from the door seal.

- Loosen the A-pillar center trim - 2 - from the A-pillar trim - 1 - using trim removal wedge (3409).

- Pull the A-pillar center trim - 2 - upward out of the A-pillar lower trim - 3 - and remove it.






Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary.

• Make sure the trim panel is installed inside the door seal.