Sealing Flange and Control Housing Cover Overview

Sealing Flange and Control Housing Cover Overview

• If large quantities of metal particles or abraded material are detected during engine repairs, it may mean the crankshaft or rod bearings are damaged. Perform the following procedure after the repair to prevent subsequent damage.

• Clean the oil passages.

• Replace the oil spray jets.

• Replace the oil cooler.

• Replace the oil filter element.






1 Vibration Damper

• Multiple versions.

2 Bolt

• 50 Nm + 90° (1/4) additional turn.

• Always replace.

• Quantity: 5

• Only use a strength category 10.9 bolt.

3 Bolt

• 10 Nm

4 Sealing Flange, Belt Pulley Side

• With an integrated seal.

• Removing and installing, refer to => [ Sealing Flange, Belt Pulley Side ] Service and Repair.

5 Cylinder Block

6 Bolt

• 60 Nm + 90° (1/4) additional turn.

• Always replace.

7 Drive Plate/Flywheel

• To remove, lock the crankshaft using the locking pin (T40069).

• The flywheel must not be pried out or the control housing cover will be damaged.

• Drive plate, removing and installing. Refer to => [ Drive Plate ] Drive Plate.

• Flywheel, removing and installing. Refer to => [ Flywheel ] Flywheel.

8 Sensor Wheel

• For the engine speed sensor.

• With a position holder.

9 Crankshaft Seal, Transmission Side

• Removing and installing, refer to => [ Crankshaft Seal, Transmission Side ] Service and Repair.

10 Control Housing Cover

• Removing and installing, refer to => [ Control Housing Cover ] Control Housing Cover.

11 O-ring

• Always replace.

12 Bolt

• 25 Nm

13 Alignment Sleeves

14 Bolt

• 5 Nm

15 Engine Speed Sensor (G28)

16 Seal

• Always replace.