Headlamps, Aiming

Headlamps, Aiming

• It is not necessary to remove the front bumper to aim the headlamps.

• Illustrations depict left headlamp.

When checking the installation position of the headlamp, if the gaps between the headlamp and body are uneven, the installation position must be corrected.

• Turn off the ignition and all electrical consumers.

• Remove the key.

Procedure

- Remove the radiator grille.

- Loosen the rear screw - 3 -.






- Loosen the top bolts - 2 - and - 4 -.

- Loosen the front screw - 1 - from the headlamp.

- Turn the adjusting bushing - arrow - on the front of the headlamp to adjust the headlamp so that it is flush with the vehicle body.






- Tighten the threaded connections to the tightening specification. Refer to => [ Halogen Headlamps Overview ] Halogen Headlamps Overview.

- Check and correct the headlamp position and make sure the gap dimensions are even.

- Install the radiator grille.

- Check headlamp for functions.

- Check headlamp adjustment and adjust the headlamps.