Gear Shift Unit Overview

Gear Shift Unit Overview






1 Gear Shift Unit

• Consisting of the gear shift shaft and the gear shift cover.

• The components cannot be separated from each other.

2 Backup Lamp Switch (F4)

• 20 Nm

• Coat the threads lightly with MoS 2 grease.

3 Locking Pin

• For adjusting the shift mechanism.

• Removing, refer to => [ Removing the Locking Pin from the Gear Shift Unit Cover ] Gear Shift Unit.

• Installing, refer to => [ Pressing the Locking Pin into the Gear Shift Unit Cover ] Gear Shift Unit.

4 Relay Lever

• With the cable retainer.

• Installed position, refer to => [ Shift Lever/Relay Lever, Installed Position ] Shift and Selector Cables Overview.

• Lubricate before installing, refer to => [ Relay Lever, Lubricating ] Shift and Selector Cables Overview.

5 Clip

• Secures the relay lever in the gear shift unit cover.

6 Seal

• Pry out with a screwdriver.

• Installing, refer to => [ Gear Shift Shaft Seal ] Gear Shift Shaft Seal.

7 Nut

• 23 Nm

• Always replace.

• Self-locking.

8 Shift Lever

• Install so that the master spline aligns with shift shaft. Refer to => [ Shift Lever, Installing ] Shift and Selector Cables Overview.

• Can be replaced with the shift mechanism still installed.

• Installed position, refer to => [ Shift Lever/Relay Lever, Installed Position ] Shift and Selector Cables Overview.

9 Cap

• For the transmission ventilation.

10 Sealing Cap

11 Spring

• Not installed in all transmissions.

• Install if present.