Windshield Wiper System

Windshield Wiper System

Always follow the instructions in the Repair Information exactly when disconnecting and connecting the battery. Refer to battery in engine compartment => [ Battery, Disconnecting and Connecting ] Service and Repair or battery in luggage compartment => [ Battery, Disconnecting and Connecting ] Service and Repair.

• Check the windshield wiper motor using the output diagnostic test mode from the vehicle electrical system control module (J519).

General Information

The Wiper Motor Control Module (J400) is integrated with the Windshield Wiper Motor (V).

To remove wiper blades, wiper arms must be driven into "service/winter position". The "service/winter position" is activated by operating windshield wiper lever in "one-touch wiping" position within 10 seconds after switching off ignition. Refer to the Owner's Manual.






DTC Recognition and Display

The Vehicle Electrical System Control Module (J519) is equipped with OBD.

Use the Vehicle Diagnosis, Testing and Information System (VAS 5051B) under "Guided Fault Finding".

Additional information: refer to the Owner's Manual.