Driver Side Instrument Panel Cover

Driver Side Instrument Panel Cover

• For reasons of clarity, the steering wheel is not depicted in the illustration, it is not necessary to remove it.

Removing

- Turn off the ignition.

- Remove the side instrument panel cover on the driver side.

- Remove the trim from the instrument panel on the driver side.

- Remove the trim from the center of the instrument panel.

- Remove center console. Refer to => [ Center Console ] Service and Repair.

- Push the headlamp switch (E1) forward and turn it to the right until it is vertical, then pull it out and disconnect it.

- Remove the screws - 1 - (1.5 Nm).

- Remove the instrument panel cover on the driver side - 2 - and disconnect the wiring harness from the instrument panel and switch illumination dimmer switch (E20).






Installation

- Install in reverse order of removal.

• Check all the fasteners for damage and replace if necessary.