Rear Left Side Airbag Crash Sensor

Rear Left Side Airbag Crash Sensor

• The left rear thorax airbag crash sensor (G256) is installed from the inside on the rear wheel housing.

Removing

The general safety precautions for working on airbag, belt tensioner and battery cut-out units (pyrotechnic components) must be observed. Refer to => [ Pyrotechnic Components Safety Precautions ] Service Precautions.

Perform the following:

- Disconnect the battery.

- Remove the bench seat. Refer to => [ Seat Bench/Single Seat ] Seat Bench/Single Seat.

- Remove the rear wheel housing trim. Refer to => [ Lower C-Pillar Trim ] Lower C-Pillar Trim.

- Disconnect the connector - 1 - from the crash sensor - 3 -.

- Remove the bolt - 4 - (9 Nm) and the crash sensor - 3 - from the body - 2 -.






Installation

- Install in reverse order of removal.

- Turn on the ignition.

Make sure no one is in the vehicle.

- Connect the battery.