Dual Clutch Overview

Dual Clutch Overview

Short Description

• The clutch contains 2 toothed plate packs. The outer, larger disc pack is called "K1 (clutch 1)". The "K1" shifts reverse gear and "1st", "3rd" and "5th" gears. The inner, smaller "K2" (clutch 2) shifts the "2nd", "4th" and "6th" gears.

• Installing the Direct Shift Gearbox (DSG(R)) clutch requires special care because: All components were balanced to each other by the manufacturer. When positioning components during installation, do no rotate them from their original position, otherwise imbalances will occur, reducing the shift comfort and the life span.

Replacement Part Package






1 DSG(R) Clutch and Lock Ring

• The drive plate (upper part of the DSG(R) clutch) of a new clutch is not secured with the lock ring, it only sits taut in the clutch.

• The drive plate must be engaged between the teeth of the exterior clutch pack.

• If the drive plate is loosened, clutch discs in the DSG clutch can slip out of place. The DSG(R) clutch may not be correctly set during installation under certain circumstances.

2 Lock Ring

• Quantity: 10, with various thicknesses for adjusting.

• When installing the clutch, the thickness of the lock ring must be determined. Refer to => [ Identify the lock ring for the DSG(R) clutch ] DSG(R) Clutch, Installing and Adjusting.

3 Clutch End Cover

4 Clutch End Cover Lock Ring

Individual Parts of the Disassembled DSG(R) Clutch

• This illustration is only an overview of the components. The DSG(R) clutch MUST NOT be disassembled at this time since all outer and inner clutch discs were installed weighted to each other.

• If the drive plate is loosened, the clutch discs in the DSG(R) clutch can slip out of place and the DSG(R) clutch may not be correctly set during installation under certain circumstances.






1 DSG(R) Clutch/Clutch Housing

• Outer clutch pack carrier.

2 Seals

• Quantity: 4

3 Inner Clutch Pack Carrier

• Do not remove.

Do not lift or remove the inner clutch pack carrier, under any circumstances. The clutch discs could rotate themselves.

4 Outer Discs

• Quantity: 4

5 Inner Discs

• Quantity: 4

6 Thrust Washer

7 Lock Ring

• If the lock ring was removed in order to install the discs, it should be replaced with a new ring of the same thickness.

8 Lock Ring

• Reset after installing a new clutch thickness. Refer to => [ Identify the lock ring for the DSG(R) clutch ] DSG(R) Clutch, Installing and Adjusting.

9 Drive Plate

10 Lock Ring

• Always replace.