Plenum Chamber Cover

Plenum Chamber Cover

Removing






- Remove wiper arms

- Pull off seal - 5 - on the entire length of plenum chamber cover - 1 and 2 -.

- Pull the retaining clips - 6 - from the plenum chamber cover.

- Pull out plenum chamber covers - 1 and 2 - starting at center carefully upward from windshield binding profile - 3 -. Always begin with the top plenum chamber cover.

Installation

Do not use any tools when installing the plenum chamber into the binding profile.






- Spray the windshield binding profile - 3 - with a soup solution to make easier to install the plenum chamber covers - 1 and 2 -.

- Place plenum chamber covers - 1 and 2 - onto binding profile - 3 - and clip it into binding profile starting from the center using light pressure. Begin with plenum chamber cover lying on bottom.

- Secure the plenum chamber cover with the retaining clips - 6 -.

- Install seal - 5 - on to plenum chamber cover and windshield wipers.

• New windshield has an insert in the binding profile. Remove the insert before installing the plenum chamber cover.

• Inspect the foam pieces - 4 - for damage; replace if necessary.