Defroster Door Motor (V107)

Defroster Door Motor (V107)

Special tools, testers and auxiliary items required

• Vehicle Diagnostic Tester

Removing

- Turn off all electric consumers.

- Switch off the ignition.

- Remove the key.

- Remove the driver side footwell cover and the footwell trim.

- Remove the left footwell vent. Refer to => [ Left Footwell Vent ] Left Footwell Vent.

- Remove the data bus on board diagnostic interface (J533).






- Remove the nuts - 1 - (9 +/- 1.3 Nm) and bolts - 3 - (9 +/-1.3 Nm).

- Remove the bracket - 2 -.






- Mark the connector - C - for the motor (danger of confusing it with other connectors that may look the same).

- Disconnect the connector - C - from the defroster door motor.

- Remove securing bolts - A - (1.4 Nm) and remove defroster door motor - B -.

- Disconnect the lever - E - from the connecting rod - D -.

Installing

Install in reverse order of removal.

• After installing, function of defroster door must be checked.

• Initiate "Basic Setting" function with Vehicle Diagnostic Tester. Refer to => [ Climatronic A/C System with Automatic Controls, Checking and Adjusting Components ] Climatronic A/C System with Automatic Controls, Checking and Adjusting Components.