Converter With Socket, 12 V-115 V (U27)

Converter With Socket, 12 V-115 V (U27)

Special tools, testers and auxiliary items required

• Trim Removal Wedge (VAS 3409)

• The Converter With Socket, 12 V-115 V housing contains chargeable capacitors.

• There is a danger of electric shock.

• The housing of Converter With Socket, 12 V-115 V must not be opened under any circumstances.

• When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool ( (VAS 3409) , screwdriver) will be positioned using commercially available adhesive tape.

• No repairs may be performed on the harness connector, on the wires and the 230V-outlet.

• If there is a fault at harness connector, at wires, at 115V-socket or in the converter, the complete unit must always be replaced.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Open the flap in front of the 115 V socket.

- Remove the trim - 1 -.






- Remove the screws - arrows -.






- Pull the lower trim first to the rear in - direction of arrow 1 - and then lift it upward in - direction of arrow 2 -. Pay attention to the wires still connected.






- Disconnect the connectors - arrows - and remove the trim.






- Release the socket at the tabs - arrows - and remove it from the trim.






- Remove the screws - arrows - and then remove the converter with socket, 12 V-115 V from the trim.






Installing

Install in reverse order of removal.