Parking Aid Sensor Mount in Rear Bumper Cover

Parking Aid Sensor Mount in Rear Bumper Cover

Removing

- Remove the parking aid sensor from the rear bumper cover. Refer to => [ Rear Parking Aid Sensors ] Rear Parking Aid Sensors.

- Squeeze both retainers - arrows - to release the outer ring - 1 -.






- Remove the outer ring - 1 - from the sensor mount toward the rear.

- Pull the sensor mount - 1 - toward the outside and out of the hole in the bumper cover.






Installing

Installation is performed in the reverse order of removal. Note the following:

• Make sure the openings for the sensor connection are facing in the right direction when installing the sensor mount as illustrated. The sensors wires will be too short if the sensor bracket is installed in the wrong direction.