Battery, Transceiver, Fuse and Wiring Harness Overview

Battery, Transceiver, Fuse and Wiring Harness Overview






1 - Positive Connection

• Red wire with suitable connection.

2 - To Terminal 15a

• Connection to terminal 15a.

• Ensure that this wire is protected by a fuse.

• Fuse maximum 15 amps.

3 - Antenna Ground

• Ensure that there is a good ground connection to the body.

• The antenna installation location must be treated with suitable corrosion protection.

4 - Transmitting/Receiving Antenna

• Installation locations, refer to => [ Transmitted Output, Antenna Installation Locations ] Locations.

5 - Shielded Antenna Wire

• Wire with coaxial connector.

6 - Telephone Or Two-Way Radio Transmitter/Receiver Unit

7 - Wiring Harness

• Voltage supply positive via red wire, 2.5 mm2 cross section.

• Voltage supply negative via brown wire, 2.5 mm2 cross section.

• If necessary, wire to terminal 15a via black wire with cross section of 1.5 mm 2.

8 - Fuse Holder

• Install next to battery.

9 - To Starter

10 - Battery

• Installation location in engine compartment.

11 - Negative Wire

12 - Body Ground