Rear Lid Adjustment Buffer, Adjusting

Rear Lid Adjustment Buffer, Adjusting

• The following describes adjusting the right adjusting buffer. Adjusting the left adjusting buffer is identical.

• Turn the adjusting buffer - 1 - 90° to remove or install it.






Perform the following:

- Loosen the clamping screw - 4 - until it is visible in the rubber buffer.

- Pull the notched slider - 3 - off of the adjustment buffer - 1 -.

- Set notched slider to dimension - a - = 12.5 mm.






- Close the rear lid in the initial locking position using light pressure over the center.

- Open the rear lid again.






- Screw in the clamping screw - 1 - of the adjustment buffer to a depth of - a - = 20 mm.

- Check the adjustment.